
ADSB Receiver Pro
장치가 라이브 항공기 ADSB 데이터 (교통 및 날씨)를받을 수 있도록합니다.
앱 정보
앱 설명
Android 앱 분석 및 검토 : ADSB Receiver Pro, HIZ LLC에서 개발했습니다. 지도/내비게이션 카테고리에 나열되어 있습니다. 현재 버전은 5.0.2이며 14/12/2024 에 업데이트되었습니다. Google Play : ADSB Receiver Pro에서 사용자 리뷰에 따르면. 9 천 이상의 설치를 달성했습니다. ADSB Receiver Pro는 현재 132 리뷰, 평균 등급 4.6 스타를 보유하고 있습니다
-이 앱을 사용하려면 추가 하드웨어가 필요합니다.
-배터리 최적화 비활성화 백그라운드에서 실행되는 경우
설명
항공 세계로 다이빙하십시오. 귀하의 자체 ADSB 수신기. 손끝에서 실시간 공기 교통 데이터를 바로 경험하고 장치를 강력한 레이더로 변환하십시오!
라이브 ADSB 데이터 (978 MHz UAT 및 1090 MHz ES)를받습니다. 지원되는 USB Dongle과 OTG 케이블 만 있으면됩니다. 둘 다 인터넷의 다양한 소스에서 $ 20 미만으로 제공됩니다. 구독이 필요하지 않습니다!
자세한 내용은이 링크를 따르십시오. 다가오는 항공기를 경고 할 범위를 기반으로 트래픽 모니터링을 활성화합니다.
GDL90 프로토콜 (예 : Avarex, IflyGPS, Fltplango 및 Avarex, IflyGPS, Fltplango 및 Droidefb). ADSB 수신기를 사용하면 다음에 액세스 할 수 있습니다.
-항공기 위치 : 고도, 속도 및 제목을 포함하여 인근 항공기의 움직임을 추적합니다.
-날씨 데이터 : 공식 Nexrad 날씨 이미지와 함께 정보를 제공합니다 ( gdl90 능력 앱), 메타, PIREP, 바람 등과 같은 항공 보고서를 사용하여.
지원 하드웨어
Rafael Micro R820T 및 R820T2 기반 튜너. 어댑터/케이블 : https://hiz.ch/fwd/hardware
{# }privacy
이 앱에는 Google지도 및 GDL90 지원에 대한 GPS 위치 권한이 필요합니다. Hiz LLC.
크레딧
Hiz LLC Copyright (c) 2014-2024, 모든 권리 보유
에 의해 수집되지 않습니다. https : // hiz. ch/fwd/credits
면책 조항
이 소프트웨어는 저작권 보유자 및 기여자 "와 그대로"및 묵시적 보증을 포함한 명시 적 또는 묵시적 보증에 의해 제공됩니다. 특정 목적에 대한 상업성과 체력은 부패합니다. 어떠한 경우에도 저작권 보유자 또는 기고자는 직접, 간접적, 부수적, 특별, 모범적 또는 결과적 손해 (대체 상품 또는 서비스 조달, 사용 손실, 데이터 또는 이익)에 대해 책임을지지 않습니다. 또는 사업 중단) 그러나 그러한 손상의 가능성에 대해 조언하더라도 계약, 엄격한 책임 또는 불법 행위 (태만 또는 기타를 포함하여).
새로운 것
Improved driver!
Added support for Android 14.
Added chart for visualization.
Added option to disable timeout.
Various speed optimizations and minor fixes.
Added support for Android 14.
Added chart for visualization.
Added option to disable timeout.
Various speed optimizations and minor fixes.
최근 의견
clive kent
enjoying the app. works fine but when I use my avare navigation local sectional I lose the valuable airspeed/altitude info. I see numbers but it must be a code that makes no sense to me. this information is there on adsb receiver pro but not when I go to my local sectional. maybe I'm missing something? otherwise would be useful in the air.
Angus Mccamant
This app has been great! It has enabled me to use the inexpensive and reliable FlightAware receiver with my tablet to put traffic on the moving map display. I have used the paid version regularly for a couple years now and when problems arose the owner of the app stepped up to keep it going.
Mark Quedsky
Pro version generally works great but a big annoyance; if no packets, app stops listening after 10 cycles of 19 seconds - or 190 seconds. There is an option to restart the app after every 30 seconds of non-reception but the restart cycle starts after only 19 seconds and reception is not active again until 11 more seconds. That means one third of the time the app is not listening for packets so also not usable. Please add an option to let it run for hours even if no packets!
Paul Young
I bought the Pro version. I connected both an ADSB 1090 SDR with antenna and filter and a UAT 978 SDR with antenna and filter SDR on a usb hub. Could only use 1 at a time and the UAT SDR packet collection is less sensitive when the ADSB SDR is connected as opposed to the other way round. Would wonder if the driver can attach to 2 SDRs simultaneously to collect 1090 and 978
A Google user
got the trial version and had a bit of trouble getting it going. The app it self installed as it should but because I was using an antenna that was too long I didn't recieve any thing. I switched to a short telescopic antenna and left it retracted. @ 5 inches total length and turned it horizontal. I seem to be limited to a 50 to 70 mile radius but I'm at the bottom of a good size valley. The developer replied to my comments in under an hr.
Ray Marx
No Chromebook version! No way to download to install to use on the device after paying for it!!! Works ok for what it is on phones, can't hear anything, just GPS/Weather reports of planes. For a pro version, I'd fully expect all of these features!
A Google user
Good app! I have no problems with map, logging and interface. But work with RTL-SDR should have some improvement: if ADS-B source is strong (you are onboard or near by) hardware AGC doesn't work well, signal overloads ADC or DSP and software can not decode packets. Resolved this problem by removing antenna. Just receive signal without any antenna attached, stable work for two hours. One of the possible solutions will be to add "Gain" option, another — implement software AGC Thanks for your work
joseph ignatowski
Tried using it on a device running android 10 Go. App won’t let me start without the “display over other apps” function enabled. 10 Go does not have the “display over other apps” feature, google removed it from 10 Go, or at least disabled it at the root level. Are there any workarounds to bypass the display over other apps requirement that do not require root permissions?